Jump to content

Recommended Posts

Posted

My daughter's JK wasn't blowing hot air, so I started digging into the heating system. Adjusted the blend door actuator to close all the way... this wasn't it.  I found a rusty spring on the radiator cap and sandy sludge inside the overflow container.

After removing the under vehicle air dams to reach the radiator, I flushed the coolant twice and flushed the heater core back and forth several times. That brought the vent temperatures up from 95 degrees to 130 on the driver's side and 150 on the passenger side.

Right now, I have a cleaner circulating through the radiator, engine, and heater core for a few days. Next, I plan to flush the entire system and heater core several more times to see if I can get full, even heat across all the vents. If that doesn't fix it, I'm looking at a 12 hour job to pull the entire dash to get to and replace the heater core, though I'll already have to do that this summer anyway to replace the leaking evaporator.

Last week was rotors/brakes/caliper for a Ford.  The Ford needed coolant hosts the week before.  And the Ford needed $9K for a replacement 10 speed transmission a couple weeks before that...  Every vehicle needs something.  An oil leak addressed, a windshield replace, emergency break tweak, suspension parts, etc...

What are you working on?

  • Wrestle +1 2
Posted (edited)
1 hour ago, jross said:

My daughter's JK wasn't blowing hot air, so I started digging into the heating system. Adjusted the blend door actuator to close all the way... this wasn't it.  I found a rusty spring on the radiator cap and sandy sludge inside the overflow container.

After removing the under vehicle air dams to reach the radiator, I flushed the coolant twice and flushed the heater core back and forth several times. That brought the vent temperatures up from 95 degrees to 130 on the driver's side and 150 on the passenger side.

Right now, I have a cleaner circulating through the radiator, engine, and heater core for a few days. Next, I plan to flush the entire system and heater core several more times to see if I can get full, even heat across all the vents. If that doesn't fix it, I'm looking at a 12 hour job to pull the entire dash to get to and replace the heater core, though I'll already have to do that this summer anyway to replace the leaking evaporator.

Last week was rotors/brakes/caliper for a Ford.  The Ford needed coolant hosts the week before.  And the Ford needed $9K for a replacement 10 speed transmission a couple weeks before that...  Every vehicle needs something.  An oil leak addressed, a windshield replace, emergency break tweak, suspension parts, etc...

What are you working on?

 

 

Probably new brakes and spark plugs during my oil change tmrw. Also chipping in for or buying 2 vehicles soon for 2 of my kids. 

Im not doing  the oil, brakes or spark pkugs myself. Too busy. 

Edited by red viking
  • Wrestle +1 1

Fighting the Good Fight Against Non-Stop Winger Lies and Hypocrisy

Posted

I’m due for an oil change soon and just had a chip mended in my windshield. The Insurance company covered the chip repair @ 100%, however I’m told a full windshield replacement has a $500 deduction. Thankfully I didn’t need that!

Posted
2 hours ago, jross said:

My daughter's JK wasn't blowing hot air, so I started digging into the heating system. Adjusted the blend door actuator to close all the way... this wasn't it.  I found a rusty spring on the radiator cap and sandy sludge inside the overflow container.

After removing the under vehicle air dams to reach the radiator, I flushed the coolant twice and flushed the heater core back and forth several times. That brought the vent temperatures up from 95 degrees to 130 on the driver's side and 150 on the passenger side.

Right now, I have a cleaner circulating through the radiator, engine, and heater core for a few days. Next, I plan to flush the entire system and heater core several more times to see if I can get full, even heat across all the vents. If that doesn't fix it, I'm looking at a 12 hour job to pull the entire dash to get to and replace the heater core, though I'll already have to do that this summer anyway to replace the leaking evaporator.

Last week was rotors/brakes/caliper for a Ford.  The Ford needed coolant hosts the week before.  And the Ford needed $9K for a replacement 10 speed transmission a couple weeks before that...  Every vehicle needs something.  An oil leak addressed, a windshield replace, emergency break tweak, suspension parts, etc...

What are you working on?

 

 

sounds like you’re well versed in automobiles too jross. 

  • Wrestle +1 1
Posted

I have a Nissan with an exhaust leak.  The check engine light had came on. The code  was related to the O2 sensor indicating it was too lean.  That could be a few different things, but the donut shaped seal where the exhaust connects to the exhaust manifold was very worn and definitely leaking.  Ordered a new seal.  Going to put that in and see if the code doesn’t come back.  I am optimistic this fixes it, as the unexpected air enter/escaping from the system could be causing the code.  I’m worried the fasteners holding the exhaust on will be too rusted and difficult to remove when I get around to making the repair.

I also have to fix the ignition on my motorcycle that was stolen a couple months ago.  Haven’t ordered the parts for that yet.  I can still ride it and my keys works it’s just many other objects can be inserted to start the bike. 

Posted
41 minutes ago, fishbane said:

I have a Nissan with an exhaust leak.  The check engine light had came on. The code  was related to the O2 sensor indicating it was too lean.  That could be a few different things, but the donut shaped seal where the exhaust connects to the exhaust manifold was very worn and definitely leaking.  Ordered a new seal.  Going to put that in and see if the code doesn’t come back.  I am optimistic this fixes it, as the unexpected air enter/escaping from the system could be causing the code.  I’m worried the fasteners holding the exhaust on will be too rusted and difficult to remove when I get around to making the repair.

I also have to fix the ignition on my motorcycle that was stolen a couple months ago.  Haven’t ordered the parts for that yet.  I can still ride it and my keys works it’s just many other objects can be inserted to start the bike. 

Had the O2 sensor code on my other daughter's (00) TJ this summer. The sensor was rusted into the exhaust. Also, one bolt in a side rail I was replacing was rusted into the frame. After enough cussing, I hired a welder to heat them out. The first set of new sensors turned out to be bad, but a second set cleared the code. At first, I thought it might be an exhaust manifold leak because there were black soot marks around the flange, even though I had already replaced it as part of the head replacement last year.

My (08) F150 sounds like it has an exhaust manifold leak...  

What type of bike and congrats on getting it back!  

Posted
4 hours ago, jross said:

Had the O2 sensor code on my other daughter's (00) TJ this summer. The sensor was rusted into the exhaust. Also, one bolt in a side rail I was replacing was rusted into the frame. After enough cussing, I hired a welder to heat them out. The first set of new sensors turned out to be bad, but a second set cleared the code. At first, I thought it might be an exhaust manifold leak because there were black soot marks around the flange, even though I had already replaced it as part of the head replacement last year.

 

 

 

 

 

My (08) F150 sounds like it has an exhaust manifold leak...  

What type of bike and congrats on getting it back!  

 

manifold leak on a Ford. common it seems

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Latest Rankings

  • College Commitments

    Eli Gabrielson

    Archbishop Spalding, Maryland
    Class of 2027
    Committed to Maryland
    Projected Weight: 133, 141

    Jackson McLees

    Travelers Rest, South Carolina
    Class of 2027
    Committed to The Citadel
    Projected Weight: 149

    Gunnar Gossett

    Union Local, Ohio
    Class of 2027
    Committed to Central Michigan
    Projected Weight: 165

    Dylan Frass

    Olentangy Liberty, Ohio
    Class of 2027
    Committed to Central Michigan
    Projected Weight: 285

    Emma Bacon

    Wyoming Seminary, Florida
    Class of 2027
    Committed to Iowa State (Women)
    Projected Weight: 131
×
×
  • Create New...